Scarlett SC-137S User Manual download pdf (Page 5)

IM010

www.scarlett.ru SC-137S

GB INSTRUCTION MANUAL

IMPORTANT SAFEGUARDS

• Please read the instruction manual before use and

save it for future references.

• Before the first switching on check that voltage

indicated on the rating label corresponds to the

mains voltage in your home.

• For home use only. Do not use for industrial

purposes. Use the steam iron only for its intended

use.

• Do not use outdoors or in damp area.

• Do not immerse the steam iron and cord in water or

other liquids.

• Never pull the cord while disconnecting from the

power outlet; instead, grasp the plug only and pull

to disconnect.

• Do not allow the cord to touch sharp edges and hot

surfaces.

• Always unplug the steam iron from the power

supply when filling with water or emptying and

when not in use.

• Do not operate the steam iron with damaged cord

or plug, or after the appliance malfunctions, or has

been dropped or damaged in any manner. To avoid

risk of electric shock, do not disassemble the

steam iron; take it to a service center for

examination, repair or mechanical adjustment.

• This appliance is not intended for use by persons

(including children) with reduced physical, sensory

or mental capabilities, or lack of experience and

knowledge, unless they have been given

supervision or instruction concerning use of the

appliances by a person responsible for their safety.

• Children should be supervised to ensure that they

do not play with the appliance.

• Do not leave the iron unattended while hot or

connected or on an ironing board.

• If ironing is interrupted, stand the iron on heel rest

only, do not place the steam iron on metal or rough

surfaces.

• CAUTION: To avoid a circuit overload, do not

operate another high wattage appliance on the

same circuit.

• If the product has been exposed to temperatures

below 0ºC for some time it should be kept at room

temperature for at least 2 hours before turning it

on.

• The manufacturer reserves the right to introduce

minor changes into the product design without prior

notice, unless such changes influence significantly

the product safety, performance, and functions.

BEFORE THE FIRST USE

• Some parts of the steam iron have been slightly

greased and as a result the iron may slightly smoke

when switched on for the first time. After a short

time this will cease.

• Remove protection cover from the soleplate and

clean it with a soft cloth.

HOW TO USE

SETTING TEMPERATURE

• Always check whether a label with ironing

instructions is attached to an article to be ironed.

Follow these instructions in all cases.

• Turn the temperature control dial round to set the

appropriate temperature indicated in ironing

instructions or in fabric label.

LABEL TYPE OF TEXTILE

Do not iron this article

• Synthetics, Nylon, Acrylics,

Polyester, Rayon

••

Wool, Silk

••• Cotton, Linen

Maximum temperature

(Steam)

• Insert the mains plug into the wall socket. The

indicator light will turn on.

• When the indicator light goes out you may start

ironing

• If you set the temperature control to lower setting

after ironing at a high temperature, it is not

recommended to iron before the pilot light switches

on again.

WATER TANK FILLING

• Unplug the iron before filling the water tank.

• Hold the steam iron in horizontal position.

• Slowly pour water through the water inlet.

• Do not fill higher than mark on the water tank, in

order to avoid spilling out of water.

• The opening which is used for pouring water

should be closed when the iron is in use.

• Always unplug the iron from the power socket

when refilling the water reservoir.

NOTE: Your steam iron is designed to use tap water.

However, if the water is very hard, it is advisable to

use distilled water.

• The water tank should be emptied after each use.

NOTE: If you empty the water tank after the steam

iron has cooled down, set the steam iron in an

upright position on its heel rest, plug it in and set

the temperature control dial to the maximum

position, heat for 2 minutes.

Unplug the steam iron

from the power supply.

SPRAYING

• As long as there is enough water in the water tank,

you may use the spray button at any temperature

setting during steam or dry ironing.

• Press the spray button several times to activate the

pump while you are ironing.

STEAM IRONING

• With the unit unplugged, fill the steam iron with

water.

• Stand the steam iron on its heel rest in an upright

position on an iron-safe surface and plug in.

• Set the temperature control dial to the “••“ or “•••”

position.

• Set the variable steam control to the desired

position

CAUTION: Avoid coming in contact with ejected

steam.

DRY IRONING

• The steam iron can be used on the dry setting with

or without water in the water tank, however it is

best to avoid having the water tank full while dry

ironing.

• Turn the variable steam control to the minimum

position

• Select the setting on the temperature control dial

best suited for the fabric to be ironed.

1 2 3 4 5 6 7 8 9 10 ... 23 24

Comments to this Manuals

No comments

Scarlett SC-137S User Manual Page 5

Comments to this Manuals

Related products and manuals for Irons Scarlett SC-137S